HVAC ducts · Glossary

Galvanised steel ductwork

Also called: GI duct, Sheet metal duct

Traditional ductwork made from galvanised sheet steel, installed first and insulated separately on site with a second fix.

Related terms in HVAC ducts

Pre-clad duct
Pre-insulated ductwork with a tougher outer cladding for exposed or outdoor runs, such as Kingspan KDuct.
Duct lagging
Insulation wrapped around the outside of metal ductwork after installation, such as mineral wool or elastomeric foam.
PalDuct PIR 30P200
A 30 mm Kingspan PalDuct PIR panel (4000 × 1200 mm) for higher pressures and air speeds than 20P80, including outdoor runs.
Duct board
Rigid insulation boards (fibreglass or foam) that are cut and folded into ducts. Phenolic and PIR panels are the modern foam-based form.
PalDuct PIR 20P80
A 20 mm Kingspan PalDuct PIR panel (4000 × 1200 mm). Kingspan's data sheet rates ducts made from it for -25 °C to +80 °C, up to 1000 Pa and 15 m/s.
Air leakage class
How airtight a duct system is. EN 16798-3 / EN 1507 classes run from A (leakiest) to D (tightest); SMACNA uses leakage classes in the US. Pre-insulated ducts can reach the tighter classes.
Kingspan PalDuct
Kingspan's pre-insulated duct panel range for the Middle East, made in Dubai. It includes PalDuct PIR and PalDuct Phenolic panels, fabricated into ductwork by approved fabricators.
UL 181
The Underwriters Laboratories safety standard for factory-made air ducts and air connectors. A Class 1 listing covers flame spread, smoke and other tests, and is widely asked for in the Middle East.

All hvac ducts terms → · Full glossary →