Raised access floors, made in Dammam.

Nord Floors manufactures raised access floors in its own Dammam factory and supplies the finishes that go on top — carpets, vinyl, entrance mats and trims — with blinds and curtains to finish the room.

4 panel series3.7–11.1 kNISO 9001 · 14001 · 45001200+ projects40+ in KAFD
Raised access floor being installed in a high-rise office in Riyadh
Questions we get asked

Raised floor FAQ

Short answers from our technical team. For anything specific to your project, send us the drawings.

Why does Nord Floors recommend 4.5 kN as a minimum?

Lighter grades can carry ordinary office loads, but a 4.5 kN panel is stiffer. It sounds more solid underfoot, transmits less footfall noise and holds up better over the life of the building. We recommend 4.5 kN as the minimum for every office.

Can I put marble or stone on a raised floor?

Yes. nSteelCement is our standard panel and takes marble, stone, porcelain and parquet: fix a plywood, cement board or fibreboard layer to the panels, then lay the finish on it. Carpet tiles, LVT and SPC go straight onto the panel. nGroove is our premium panel for projects that need the hard finish bonded straight to the panel with no board layer.

Can a MEWP or scissor lift be used on a raised access floor?

Yes, on 6.8 kN grades and above. Nord Floors floors at 6.8 kN carry MEWPs on site today. Forklifts and pallet stackers are possible on heavy grades after Nord Floors engineering checks the wheel loads.

When does a raised floor need stringers and mechanical anchoring?

nHPL and nSDV are gravity-laid systems, so they use stringers at every height, from the lowest. nSteelCement and nGroove are corner-locking systems, fixed to the pedestal heads at each corner, so they need stringers only above 600 mm finished floor height. Up to 600 mm, chemical (adhesive) anchoring of the pedestals is enough; above 600 mm, pedestals are mechanically anchored to the slab.

Which standard are Nord Floors raised floors tested to?

Nord Floors follows the CISCA (Ceilings & Interior Systems Construction Association) Recommended Test Procedures for Access Floors for concentrated, ultimate, uniform and rolling loads.

Is woodcore (chipboard) raised flooring suitable for Saudi Arabia?

Usually not the best choice. Woodcore panels have a compressed wood-chip (chipboard) core, made for dry indoor conditions. Coastal humidity in Jeddah and Dammam, water from cleaning or leaks, and wet works during construction can make the core swell and lose strength. Woodcore is combustible (typically Bfl to Dfl fire classes), and many woodcore systems are rated only at light to medium grades. Steel cementitious panels such as nSteelCement are non-combustible (A1), do not swell with moisture, carry 3.7 to 11.1 kN, and last the life of the building; the steel shell is fully recyclable at end of life.

When do I need nHPL or nSDV?

Only where the room needs antistatic (nHPL) or static dissipative (nSDV) flooring, such as data rooms, server rooms and control rooms. Both come with their final finish factory-applied.

How many perforated panels or air grilles does a room need?

Only as many as the cooling needs. They are sold by the piece, not by the square metre. Divide the airflow that reaches the floor (cooling units running, minus leakage) by the airflow one panel passes at the design underfloor pressure. Our perforated panel calculator walks you through it from your CRAC datasheet.

Is Nord Floors raised flooring made in Saudi Arabia?

Yes. All four series are manufactured by Nordinfini in Dammam Industrial Area 2 and supplied across Saudi Arabia and the GCC.