HVAC ducts · Glossary

Duct lagging

Insulation wrapped around the outside of metal ductwork after installation, such as mineral wool or elastomeric foam.

Related terms in HVAC ducts

Galvanised steel ductwork
Traditional ductwork made from galvanised sheet steel, installed first and insulated separately on site with a second fix.
Duct board
Rigid insulation boards (fibreglass or foam) that are cut and folded into ducts. Phenolic and PIR panels are the modern foam-based form.
Pre-clad duct
Pre-insulated ductwork with a tougher outer cladding for exposed or outdoor runs, such as Kingspan KDuct.
Air leakage class
How airtight a duct system is. EN 16798-3 / EN 1507 classes run from A (leakiest) to D (tightest); SMACNA uses leakage classes in the US. Pre-insulated ducts can reach the tighter classes.
PalDuct PIR 30P200
A 30 mm Kingspan PalDuct PIR panel (4000 × 1200 mm) for higher pressures and air speeds than 20P80, including outdoor runs.
UL 181
The Underwriters Laboratories safety standard for factory-made air ducts and air connectors. A Class 1 listing covers flame spread, smoke and other tests, and is widely asked for in the Middle East.
PalDuct PIR 20P80
A 20 mm Kingspan PalDuct PIR panel (4000 × 1200 mm). Kingspan's data sheet rates ducts made from it for -25 °C to +80 °C, up to 1000 Pa and 15 m/s.
ASTM E84
The tunnel test that gives a surface burning rating: a flame spread index and a smoke-developed index. Duct materials in the region are often required to be Class A (flame spread 25 or less, smoke 50 or less for ducts).

All hvac ducts terms → · Full glossary →